Loading...
  1. Dismiss Notice
  2. Dismiss Notice
  3. Dismiss Notice
  4. If this is your first visit, you may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Ascension 3.0 Referral System Vote Rewards Program New user

Recent Content by Luccaaa

  1. Luccaaa
    Post

    Solved XignCode Module

    it worked! can play!
    Post by: Luccaaa, Jun 13, 2018 in forum: Problems
  2. Luccaaa
    Post

    Solved XignCode Module

    Nice, ty, i'll try
    Post by: Luccaaa, Jun 13, 2018 in forum: Problems
  3. Luccaaa
    Post

    Solved XignCode Module

    Made a GamezAIon folder and downloading gamezAION 5.3.torrent there, after i'll download the launch that u gave me, and i'll se if it works, thnx...
    Post by: Luccaaa, Jun 13, 2018 in forum: Problems
  4. Luccaaa
    Post

    Solved XignCode Module

    And hwn downloaded NCsoft launcher it downleaded in a different foler, i have NCsoft and NCwest, dunno why But, when downloaded it, i downloaded...
    Post by: Luccaaa, Jun 13, 2018 in forum: Problems
  5. Luccaaa
    Post

    Solved XignCode Module

    Post by: Luccaaa, Jun 13, 2018 in forum: Problems
  6. Luccaaa
    Post

    Solved XignCode Module

    What do u mean exactly? When downloaded it i did by utorrent, stopped it, selected downleading location (Aion NCsoft) , forced to re-check ti and...
    Post by: Luccaaa, Jun 13, 2018 in forum: Problems
  7. Luccaaa
    Post

    Solved XignCode Module

    IF run it as admit it says can't find aion.exe or aion.bin
    Post by: Luccaaa, Jun 13, 2018 in forum: Problems
  8. Luccaaa
    Post

    Solved XignCode Module

    It didn't, because not using any antivirus and i'm not using any type of program, when i open aion NA it goes normally but when i try to run...
    Post by: Luccaaa, Jun 13, 2018 in forum: Problems
  9. Luccaaa
    Thread

    Solved XignCode Module

    When i open the GamezAion launcher it says cannot regist XignCode Module and closes it, what should i do?
    Thread by: Luccaaa, Jun 12, 2018, 18 replies, in forum: Problems